how to see network mac address in windows server 2012

The techniques that I have shown you tend to be most useful when you need to configure multiple machines.Figure 1-2 Network And Sharing Center provides quick access to sharing, discovery, and networking options. If you want to remove the IP address with PowerShell, use the following command Remove-NetIPAddress -IPAddress ''Īs you can see, it is relatively straightforward to configure TCP/IP through PowerShell. Replace with your required primary and secondary DNS server addresses. Set-DnsClientServerAddress -InterfaceIndex 'IndexNo' -ServerAddresses ', ' to set a new DNS server address, type the command with the below syntax. Now one thing is missing which is the DNS server address. Up till now, we have configured IP address, subnet mask, and Default-gateway successfully. Note that the prefix length specifies the subnet mask of IP address. Replace the command parameters with your own addresses. Suppose we have the following required configurations:

New-NetIPAddress -InterfaceIndex “IndexNo” -IPAddress -PrefixLength 24 -DefaultGateway To set a new IP address, execute below command. To specifically get the Interface index, type Get-NetAdapterĪll of the above commands are used to view current configurations. It gives IP address information along with its default gateway, DNS information, and Interface index.įrom Get-NetIPConfiguration Result, note down the index number of the adapter for which you want to change IP address. Get-NetIPAddress gives IP address information with prefix length and address family.Īlternatively, you can type Get-NetIPConfiguration to get some advanced details. To see the current IP configuration, type Get-NetIPAddress in PowerShell Get-NetIPAddress To open PowerShell, type PowerShell in the search bar of your Windows 10 computer and then press Ctrl+Shift+Enter to launch it with administrator privileges. Tasks done with PowerShell can not only automate but also save you time. It is more powerful than Cmd and offers more flexibility. With PowerShell, you can gather information, change system settings and automate almost everything in Windows. PowerShell may sound difficult and you may be hesitant to work with it, but it has some unique features. With PowerShell, you can easily do this tedious task. But what if you have to do this on multiple systems and repeat all these steps several times? Then it becomes really annoying. Just go to Control Panel > Network and Internet, select the IPv4 properties and change the IP address. You may know how to change the IP address via the GUI.

How to see network mac address in windows server 2012