how to use aircrack with dynamically created password

If the key index is more than zero, WEP40 will be displayed. CCMP is used with WPA2, and TKIP is used with WPA. One of the WEP, WEP40, CCMP, WEP104, TKIP, or WRAP is detected by the cipher.

OWE is used to indicate Opportunistic Wireless Encryption. The WPA and WPA2 association is allowed if WPA3 is with TKIP. It will show WPA3 if CCMP or TKIP is present. WEP is used to show static or dynamic WEP, and WPA, WPA2, or WPA3. If the network has enabled QoS, it will display 'e' following the MB speed value. After about 54, the dot shows the preamble is supported. Anything is higher than 802.11n or 802.11ac. It shows the maximum speed, which is supported by AP. Note: because of the overlapping channels or radio interference, they sometimes capture the packets from other channels even if there is no airodump-ng. It shows the channel number, which is taken from beacon packets. It measures data packets over the last 10 seconds. It shows the number of data packets per second. It shows the data broadcast packets and the number of data packets that they capture. At the lower rate (IM), about ten beacons per second are sent by each access point, so they can usually be picked up from very far. It receives frames that have a sequence number, which is added by sending an access point.ĪP sends the number of announcements packets.

The signal level reporting will not be supported by the driver if the PWR of all clients is -1.Īll data frames and management measure by RXQ. It means the communication which we are hearing is only 1/2. If clients have PWR as -1 for limited stations, then it is for the packet that the client receives from AP, but for our card, client transmissions are out of range. The signal level reporting is not supported by the driver if the BSSID PWR is -1. Based on the driver, it is significantly dependent, but we will get close to signal or AP if the signal gets higher. In the not associated state, for connection, it is searching for AP. In terms of the client section, BSSID of an unassociated state means any AP does not associate with the client.

It shows the MAC address of the access point. In the above screenshot, the current channel, elapsed running time, and current date in the first line. The screenshot of airodump-ng is as follows: A list of connected clients and the list of a detected access point are displayed by airodump-ng.

How to use aircrack with dynamically created password